Back in 2008 I started experimenting with time lapse photography. I began with, and still use, a Canon Rebel XT with a TI-83 calculator as an invervalometer. I haven’t been doing as much time lapse photography as I’d like lately, however the steps and tips still apply.
- Set-up your shot. Use a tripod or sturdy location to place your camera. For the time lapse above I put mine on a tripod in the corner of the room.
- Take a test shot. Take a test shot of the area to calculate your exposure and to set the focus. I knew I wanted about a 2 second exposure, so I took my test shot in Shutter Priority mode.
- Adjust the camera settings. Switch the camera into manual mode. Use your test shots exposure information to set the aperture. Set the shutter speed to what you used in step 2.
- Turn off auto white balance. Set it to a preset or custom. Basically make sure any auto features are not on auto, otherwise you’ll get a nasty flicker.
- Take another test shot. Only do this if you have easy access to the viewfinder, and use a remote to avoid camera shake. This shot is just to make sure the images are properly exposed using the manual settings.
- Setup your intervalometer. I used a TI-83 calculator as my intervalometer. See the links below for the instructable. I set mine to fire in 5,000 TI-83 cycles, which worked out to be around every 10 seconds.
- Hook ’em up together. Hook up your calculator (or intervalometer) to your camera and press start.
- Wait. For me, waiting wasn’t that bad since I was busy installing the ceiling fan. But doing a nature time lapse will require a significant time commitment. For my example the time was just about 1.5 hours.
- Compile the video. After the sequence is done and you’ve downloaded your images its time to make the video. I used QuickTime Pro as it was the easiest method and gave me the best results. I tried a few free applications, which worked, but I liked the flexibility QT Pro gave me. In QT Pro simply go to “File -> Open Image Sequence…” and then chose the first picture. Be sure to set your Frame Rate at something between 10 and 30. I used 15 for mine. If your files are numbered sequentially QT will be able to figure out which pictures to add. From there you can “File -> Save As…” a QuickTime .MOV or you can “File -> Export” to a number of different formats. If your video is long enough you can add music and the like. See the links for some sites to get free creative commons licensed music.
- Post your video. I put mine on Flickr, but you can put yours on YouTube, Vimeo or any other video sharing site.
- Sutter Speeds: Be sure to pick a shutter speed that will give you a good time lapse effect (ie- movement). If you have a shutter speed that is too fast you’ll end up with a choppy looking video.
- Interval Times: The interval times (time between shots) should also be set for your subject. For slow moving subjects you can have more time between shots. For fast moving subjects you’d want less of an interval. For example, for clouds you’d want to take a shot every second or so.
- Battery Power: Make sure you have enough battery power in both your camera and your intervalometer. If you’re expecting things to take a while plug into AC power (if its near), use a power inverter, or a battery grip.
- Image Settings: Set your camera to use JPG (you won’t need RAW for this) and at a size that you think is reasonable. If you don’t it will make your post processing more difficult as you’ll have to convert all your RAW images to JPG and then re-size them. I started in RAW not knowing any better and alot time was spent converting and re-sizing. Save yourself the trouble and do it in the camera.
- Time Lapse FAQ
- Turn a TI-83 into an Intervalometer
- PhotoLapse (Software)
- JPGVideo (Software)
- CC Mixter (Music)
- Jamendo (Music)
- Creative Commons Search (Music)
Hope you all enjoy, good luck and have fun with your time lapsing!